The iPhone 3G digitizer is covering of transparent plastic that fix over the LCD screen and preserves the highly expensive component against disadvantageous scratches and cracks. The digitizer expertly gains control over the touch input mechanism for making device functions smoother, if your iPhone’s digitizer gets damaged, it will not serve to fulfill its usefulness. The digitizer is a low cost preservation imperative, that can be replaced it from your side by making use few simple tools. Enjoy greater relationship with this innovative Black White LCD Screen Glass Digitizer, which is hasty remedy against experiencing unnecessary fatigue by adversely effecting eyes in executing iPhone with dullness in color.
Instructions
1. There is no need no pay out dollars to the technician with the Black White LCD Screen Glass Digitizer Assembly for CDMA Version Sprint iPhone 4. Turnoff your iPhone. Hold your device in stand position, as well as insert the end of paperclip into a small hole located at the top of your iPhone 3G. The sim card tray will come out, draw it out and remove it from the iPhone.
2. Flipping on the iPhone 3G over and look at the bottom. The two tiny Philips screws should be removed that are on ports surroundings.
3. Now, you need placing of suction cup at the top of the face of digitizer. Lift up on the suction cup in order for the digitizer and LCD to be removed from the rest of the iPhone. Be cautious while lifting up, because of the presence of few cables between digitizer and the control board.
4. Tilt the digitizer in order to get it in vertical position thus you will visualize cables and connectors located at end of control board. With your pry stick at the top right corner of the board there are two connectors lift them up there. This will reveal ZIP connector. Flipping up the latch located at the top of connector, then pulling up on the digitizer as well as LCD that will remove them from the rest of the device.
5. Black tape covering on the one side of LCD assembly now needed to be pulled out. On that particular side of assembly, remove the three Philip screws there; no to the other side simply flip over the assembly. Also, remove the two screws located on that side of assembly.
6. Now, on the edge of metal LCD backing one Philip screw is required to be removed. This screw is exactly on the same side as the LCD assembly and the cables, which have connectivity with the assembly to the control board.
7. It time now, in order for the insertion of pry stick between the iPhone’s LCD and the clear glass digitizer. The pry stick around the perimeter of the LCD requires movement until it is grabbed, as well as lifted up.
8. Isolate the digitizer, as well as make replacement by putting digitizer in its place. Now, replacement of sic screws, as well as placement of LCD back into the digitizer is needed. Into the main device housing place out the reassembled LCD and digitizer back, as well as make sure the reattachment of three cables you have disconnected. It time now, for returning the two screws located at the bottom of device, as well as insertion for SIM card into the opening is required at the top of the iPhone 3G.
This entry passed through the Full-Text RSS service — if this is your content and you're reading it on someone else's site, please read the FAQ at http://ift.tt/jcXqJW.
No comments:
Post a Comment